|
jumep
|
|
11.01.2010 17:28 -
Re: Olej do automatické převodovky
|
|
 |
tak neviem ci je to spravne, toto pisu ako ze tam ma byt:
4HP20 and A4 autoactive automatic gearboxes: All countries: Special oil distributed by CITROEN pn: 9736 22
iny dokument o 4HP20 (ale starsej verzii) hovori: Exclusive oil ESSO LT 71141
navod v anglictine na tu al4 aj s obrazkami (prelozim to neskor)
cast 1 (anglicke forum)
You will need the following tools. Long necked funnel, sockets or spanners big enough for the drain plugs, long extension with socket for filling hole. Proceed as follows
1. Get transmission to operating temp, 10k drive should do it.
2. Support car level high enough so you can undo the drain plug.
3. Remove filler plug near gear selector. May need to move gear lever to D to get access.
4. Undo large drain plug and remove assembly, clean. Catch oil in container
5. Refit drain plug assembly and then put 4 litres of oil in through the top.
6. Run engine and move gear lever through all positions., Let engine run for a few minutes.
7. Keep engine running and remove centre drain plug, some oil will run out, when oil stream breaks into drips, refit centre drain plug.
You will waste 100ml of oil or so but this is the way Continentals do it and is the only way to get the level right. If you try and guess the right amount you run the risk of running the transmission with insufficient oil in it
(cast 2)
Put the car on high suspension position and chock each side at the jacking points as a bare minimum. The jacking point in that position is approx. 22.2 cm from the ground when high is selected.
Remove the under tray assembly. On mine, 10mm bolts and 4 slotted screws.
.link.
Here's where the drain plug and filler level tube are located. Yes, your car too should be as clean as this one.
.link.
The drain and oil level plug looks like this when removed. Use a 27mm ring spanner, it isn't too tight. Remember that when you are replacing it to the tranny.
.link.
Here are the tools required.
Slotted screwdriver
10mm socket or ring/open end spanner
27mm ring spanner
35cm of extension for the filler plug removal, for removal of filler plug from above
8mm square socket or key steel.
Infrared Thermometer - Bit of a wank really, trans needs to be very warm to touch on refill. In other words at operating temperature.
Funnel, at least 38cm long with a base diameter no greater than 14mm.
.link.
.link.
This is the location of the filler plug, it's right behind the transmission shift selector rod and cable. It is a little easier if Drive is selected prior to starting the job.
.link.
Here's the filler plug, 8mm square hole. A piece of key steel, or the material of your choice, a snug fit is what you seek. Don't lose the copper sealing washer.
.link.
Here's the oil, genuine article only is suggested. Citroen and Pug part number
9736.22 This is a 2 litre container. Two will be required.
takisto hovori o pn: 9736 22 ... (a tiez ze to je 2l nadoba a potrebujes 2ks) |
| |
| |
Nastavení
